Binding RC Remote to AeroDrone

Follow these simple steps to “bind” your RC remote control to your AeroDrone system:

Step 1

Open up Mission Planner on your computer.

Step 2

Ensure the RC remote control is switched off.

Step 3

Power up the drone and connect to it using Mission Planner.

Step 4

Once Mission Planner has connected to the drone go to the Radio Calibration screen (Initial Setup > Radio Calibration).

Step 5

Click on the “Bind DSMX” button as shown below.

Step 6

Check to make sure the RC receiver mounted on the drone is now flashing orange.

Step 7

Hold down the “Bind” button on the top of the RC remote as show below. While still holding down the “Bind” button, turn the RC remote control “On”. You should hear it beep a couple of times.

Step 8

Verify that the RC receiver mounted on the drone now has a solid orange light. If so, the bind process is complete and you should now be able to use your RC remote to control your drone. If not, go back to Step 5 and try again.